End mill holder Weldon BT 40 - 12 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

For DCONWS = 60 only with four fixation screws according to DIN 912

The 3D probe impresses with its slim and attractive design

Only nominal size d can be clamped (applicable up to 120 bar)

For d = 60 only with four fi xation screws according to DIN 912

For setting the tool in the HKS collet chucks

01mm to the centre axis

with test certificate

ER-system with spray nozzles

6 stepped block pairs (12 pcs)

see article description

- in case/box

For horizontal and vertical clamping of round and flat workpieces