Nozzle/Die with Integrated Melt FilterIn stock, ready to ship. The Filastruder melt filter is designed to keep contaminants out of your newly produced filament by filtering the polymer just before it leaves the nozzle. Note that for use with printers having a nozzle size 0. 5mm or smaller, it is recommended that a melt filter nozzle is used with the Filastruder to remove any dust debris from the polymer. It uses a 250 micron wire mesh filter, and has 75sqmm of effective filtration area.

For use with 1

Mandala Rose Works has gone thru several iterations of these to assure a great install and good fit on your Jubilee

Some show the board on the bottom

Green LED to indicate Z probe triggering and successful programming

Steve White and have been tested and approved for use in your build

Expansion options include the CAN-FD bus

It can be rotated in 90 degrees increments in order to mount the extruder according to your needs

secondary gear with integrated needle bearings

Obviously I also had to hook up a PanelDue for sweet touchscreen action

26mm Body length

The Mount is clamped between the motor and the rear housing of the extruder

Generally +/-0