GEOMETRIC OVAL FRAME DIE SET - GINA MARIE DESIGNSApprox 5. 25x4. 25 in size. Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using

I also found on one of my machines if I ran it through and then removed the outer layered and just kept the inner piece or vis versa I got a deeper cut without even shimming

Die measures 4x4 in size

PLEASE NOTE this die is a smidge smaller than a 4

Please note the Mr & Mrs die is sold separately

4x4 largest layer

Die is approximately 4

The inner lattice panel is VERY tiny and petite

Approx A2 sized

There are 99 self adhesive dots per pack

Measurements

A2 sized 4

Smallest is 1