BRANCH STYLE TREE DIE - Gina Marie DesignsMeasures 2. 88x3. 25 TIPS AND TRICKS FOR DIE CUTTING When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut using this

winged ball 3

You dont have to do this but if a die is proving a little more difficult it is good to try this

Please note the Mr & Mrs die is sold separately

It frames beautifully on an A2 card

If that is not something you are willing or wanting to do

The longest is approx 3 inches and they are just over

THEY SHOULD BE BRAND NEW BUT THERE COULD BE A FEW IN WHAT WE ARE SELLING THAT MAY HAVE A STAMP OR TWO IN THE SET USED

THE FULLEST DARKEST STAMP LAYER IS THE FIRST LAYER

papers and plate life can effect the cuts you get

please do not buy these dies

Prior to shimming a die if needed try to remove the "outer paper" and run the die back through your machine

Die cuts a 4x4