PEEKABOO RECTANGLE DIE SET - Gina Marie DesignsThese dies are similar to our scalloped frame dies except the outer cutting edge has been removed. So just the middle scalloped area cut with the stitch marks. Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping

65 tall by 3

That means you could need to shim or use a precision plate and that there will be LOTS of little pieces

Largest layer measures 4x5

Largest measures 5

PLEASE READ -

Measurements

5 inch wide

Largest layer cuts 4x4

largest layer measures 4x4

Largest die measures 4x4

The card in the photo are those actual measurements and the die is nested just inside

Prior to shimming a die if needed try to remove the "outer paper" and run the die back through your machine