Plastics piping systems for pressure and non-pressure drainage and sewerage. Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin1 Scope This document specifies the properties of piping system components made from glass reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP). It is suited for all types of drainage and sewerage with or without pressure. This document is applicable to GRP UP piping systems, with flexible or rigid joints with or without end thrust load bearing capability, primarily intended for use in direct buried installations. NOTE 1

Note: BS EN 12050-2 does not apply for pumping installations for drain and sewer systems outside buildings for pumping of municipal wastewater according to EN 752:2008

Who is BS EN 12312-18 - Aircraft ground support equipment for

They indicate the usefulness of resins for the manufacture of plasticized dry blends

Who is ISO 11120 - Refillable seamless steel tubes for

XTT cytotoxicity test

enclosures giving the appropriate degree of protection are used

This standard is also applicable to certain hazardous environments but does not exclude additional requirements which are applicable in particular circumstances

This part of ISO 9735 for batch EDIFACT security defines the security key and certificate management message KEYMAN

in order to support the wide range of engineering viewpoints that might be adopted by individual vendors or eHealth programmes

It provides some alternative approaches to existing codes for fire safety and allows the effect of departures from more prescriptive codes and regulations to be evaluated

technical basis

The sizes and octet ordering of various multi-octet service parameters